 |
|
|
 |
|
 I soldered longer wires to the piezo leads, used heat shrink tubing to cover solder joints, secured wire with cable ties. Piezo Sensor is attached with a circle 3M double sided foam tape cut to the size of the ceramic part of the piezo. |
 I cut the foam sanding block into 1"x1"x1.5" foam blocks with a miter saw and peeled off the sanding surface. The sanding block foam worked so well in my first project. I chose to use them again for this project. If you don't want to use foam blocks. You can also make foam cones from the foam sanding blocks. |
 A circle of 3M double sided foam tape the size of the ceramic is used to attach foam block to sensor. I adjusted the sensor support so the foam block is 1/8" above the rim of the drum shell. |
 Soldered wires to the 1/4" jack. Insert the 1/4" jack through the vent hole and tightened down. Put on some window screen mesh heads. One down and three to go. Next I will convert the bass drum. |
 |
 |
|
Play Rock Band, GHWT with your electronic drum kit |
 FOR SALE-GHWT Xbox 360 midi controller |
 FOR SALE-GHWT Xbox 360 midi controller with 1/4" drum inputs |
 FOR SALE-GHWT PS3,PS2 midi controller |
|
Rock Band Mods
E-drum
Resources
VDrumLib |
|
|
|